Initial Use; Battery Installation; Getting Started - auna Snozzer Manual De Instrucciones

To use the appliance with batteries ensure that the power cord is NOT connected to the mains and install
the batteries into the battery compartment. Insert 4 x AA 1.5V alkaline batteries (not included) in accordance
with the diagram in the battery compartment. Take care to observe the correct polarity (+/ -).
Please Note:
All DAB+ radios use more power during use than „traditional" radios and so will batteries run down within
a few hours. Therefore the use of mains power (or rechargeable batteries) is recommended for extended
listening. Always switch off using the ON/OFF switch at rear when the device is not in use. Standby mode
continues to use power and will flatten the batteries within a couple of days.
• Insert the adaptor cord into the power socket at the rear of the radio. Plug the adaptor into the mains
supply socket.
OR
If using the radio with batteries ensure that the power cord is NOT inserted into the back of the appli-
ance and install the batteries into the battery compartment.
• Fully extend the telescopic antenna.
• Move the ON / OFF switch at the rear of the radio to the „ON" position. The display will illuminate, a
welcome message will be displayed briefly and then the clock (00:00:00) will be shown
• Press STANDBY to turn the radio on and start to tune in. DAB+ mode will automatically be selected
and the radio will perform an autotune full scan. The display will then show „searching", together with
a slide bar indicating the scan progress and the number of stations found.
• When the scan is finished the radio will play the first alphanumerically found station. The display will
show the station that is currently playing.
• If the radio does not find any stations, „No signal DAB+" will be displayed. Ensure the antenna is fully
extended or try moving the radio to another location (near a window may be better) and repeat the
above steps.
• Adjust the volume to the desired level using VOL + or VOL – buttons.
• To search the stations that have been found, press the FORWARD or BACKWARD (11) buttons to scroll
through the available stations.
• Press STANDBY to place the unit in standby mode.
14

Initial Use

Battery Installation

Getting Started