Werner AA1510 Instrucciones De Instalación página 8

Step 6
Handrail Assembly
TOOLS REQUIRED
ADJUSTABLE WRENCH/PLIERS
The handrail can be attached to either side of the ladder. It is advisable to attach the handle only after attaching the power
pivot arm.
1. Attach the handrail to your chosen side of the rear frame (See Figure J).
2. Use 3 spacers (E1), 60mm bolts (E2), washers and nuts (E3 & E4) supplied.
3. You have a choice of 2 different handrail heights which will be
dependent on the amount of "in-attic" handrail you require (See
Figure J).
Check that all components of the whole assembly are fully secure.
*Position 1 attaches handrail
in top position.
**Position 2 attaches handrail
in low position.
Note: Position of the handrail
will affect the amount of space
needed in the attic.
Step 7
Finishing Opening for Door
TOOLS REQUIRED
SAW
SCREWS / NAILS
PHILLIPS SCREWDRIVER (small and medium)
Use a standard 1 x 3 solid wood plank for the door frame and a standard 1 x 2 solid wood board for the door jam.
1. Measure the width of the opening and cut the 1 x 3 wood board. Nail the trimmed 1 x 3 wood board to the header.
The bottom of the wood door frame should be flush with drywall on ceiling. Repeat for length of opening. (Figure K)
2. Measure inside width of frame and cut the 1 x 2 wood board. Nail the trimmed 1 x 2 wood board to the wood door
frame recessed the thickness of the door to create the door jam. Repeat for length of frame. (Figure L)
Figure K
7
E3
E1
E2
Handrail
E1
E2
Jam should be recessed
the thickness of door
PARTS REQUIRED
E1. (3) HANDRAIL SPACERS
E2. (3) M5 x 60mm BOLTS
E3. (3) 25mm DIAMETER WASHERS
E4. (3) M5 LOCKING NUT
Handrail
1*
E1
E2
E4
Figure J
PARTS REQUIRED
Standard 1 x 3 solid wood board (Door Frame)
Standard 1 x 2 solid wood board (Door Jam)
Your choice of finishing wood
Figure L
1*
2**
2**
1*
2**
E2
E1
Caution: Use of
materials greater than the
recommended thickness
may make the opening too
small to be usable.