Setting Up Or Adhering The Device - MT.DERM artyst NR.1 Instrucciones De Uso

NOTICE
Damage caused by condensation
If the device is exposed to significant varia-
tion in temperature, e.g. during transport,
condensate may form on the inside and
cause damage to electronic components.
Ensure that the device has reached
E
ambient temperature before using it. If
it was exposed to high temperature
fluctuations, wait for at least 3 hours for
every 10 °C of temperature difference
before putting it into operation.
Only use the device at ambient tempera-
E
tures of +15°C to +25°C (+50°F to +95°F).
5.1

Setting up or adhering the device

CAUTION
Risk of short-circuit
If there is visible damage to cables or cable
connections, there is a risk of electric
shock and damage to the electronics.
Perform a visual inspection of the de-
E
vice and the cables for damage, e.g. a
defective cable connection.
Never bend the product cable.
E
artyst NO.1
NOTICE
Device damage due to little stability
If the device is not placed securely, safe op-
eration is not guaranteed. The device can
fall during operation and be damaged.
Position the device on a clean, stable
E
and level surface.
Keep the buttons and display of the de-
E
vice freely accessible during operation.
Never place the device on or under
E
other devices.
The device can be positioned on a level
surface with the supplied metal plate (b).
The magnetic surface on the rear side of
the device can be used to adhere it to
metallic surface (a and d), e.g. on the leg
of a table or cart. The device can be ad-
hered in a vertical arrangement or ro-
tated 90° (c).
Positioning the device on the metal
plate:
NOTICE
Device damage due to little stability
If the device is not placed securely, safe op-
eration is not guaranteed. The device can
fall during operation and be damaged.
Position the device on a clean, stable
E
and level surface.
Keep the buttons and display of the de-
E
vice freely accessible during operation.
Never place the device on or under
E
other devices.
EN 33