Publicidad
7. Handle
8. Motor shaft
9. Speed control
10. Activate/deactivate oscillation
11. Motor
12. Extension pipe
13. Thumb screw for extension pipe
14. Base pipe
15. Fan base
16. Weight for the base
17. Washer
18. L-shaped screw
19. Small thumb screw (for easy adjusting)
20. Small screw
21. Pipe fixture
22. Long screw
23. Big thumb screw
Assembly
1. Put and fasten the L-screw (18.) through the
washer (17.), weight for the base (16.) and the fan
base (15.).
2. Fasten the extension pipe (12.) onto the fan
base (15.).
3. Loosen the screws (19.), (20.), (22.) and (23.).
4. Place the motor (11) on the upper part of the
pipe fixture (21.).
5. Fasten the screws (19.), (20.), (22.) and (23.).
6. Use the thumb screw (19.) to adjust the fan
angle.
7. Remove the protective plastic from the motor
shaft (8.).
8. Loosen the 4 fan guard screws (5.). See image
"AB".
9. Place the fan guard (back) (6.) on the motor
(11.) and fasten 4 fan guard screws (5.). Make
sure the fan guard is placed securely against the
motor and the handle (7.) is at the top.
10. Loosen the screw for the fan blade (3.). Place
the fan blade onto the motor shaft (8.).
11. Align the screw for fan blade (3.) with the flat
groove on the motor shaft (8.). Fasten the screw
for fan blade (4.). Ensure that the fan blade (3.) is
fixed on the motor shaft (8.).
12. Remove the fan guard screw (2.) from front
fan guard (1.). Open the fan guard's clamps (1.),
put the fan guards together and squeeze the
18
clamps together. Fasten the fan guard screw (2).
See image "EF".
13. Double check that fan guard is securely
mounted.
14. The fan should now be fully assembled, check
that the fan is stable.
15. Loosen the thumb screw for extension pipe
(13.). Fasten it at desired height.
16. Place the fan on a stable, flat, dry surface.
17. Check that the fan is switched off.
18. Insert the power plug of the fan into the
mains. The fan is ready to operate.
Speeds and power
"0"= OFF, "I"= low speed, "II"= medium speed, "III"
= high speed.
To switch off the fan, set the switch to position "0"
(Off) and pull out the power plug from the mains.
Oscillation
Push and pull the oscillating knob (10.) to activate
or deactivate oscillation (swinging motion).
Angle adjustment
Caution: The fan should always be switched off
and disconnected from the mains when making
angle adjustments.
Use the thumb screw (23.) to adjust the fan angle.
Loosen the screw, adjust and then fasten the
screw.
Cleaning and maintenance
Before cleaning, switch off the device and
disconnect the product from the mains. Never
clean this product when it is connected to power!
Use a soft dry cloth to clean the product.
Keep the ventilation on the back of the fan free
from dust.
Do not use detergents, abrasive cleaning
products or polishing cleaning products to clean.
They can damage the surface of the fan.
For storing the product we recommend using the
original carton. Store in a cool and dry place
protected from dust.
Properties
Rated voltage: 220-240V ~ 50Hz
Power: 50 W [FT-561], 60 W [FT-562]
Support
More product information can be found at
www.deltaco.eu.
Publicidad
