Changing The Rf Output Power - Sony WRT-847A Manual De Instrucciones

Settings
1
Set the transmitter to Setting mode.
2
If the compander time constant indication ("TC: S" or
"TC: L") is not displayed, press the SET button until it
appears.
3
Press the + or – button to change the TC setting.
+ button
AF RF BATT
– button
4
Once the desired indication appears, set the POWER
switch to the off position to release Setting mode, or
press the SET button to continue operations in Setting
mode.
The next time you turn on the transmitter (by setting the
POWER switch to ON), the transmitter enters the TC setting
selected.

Changing the RF Output Power

You can select the RF output power from two levels of
50 mW or 10 mW in Setting mode.
Check "H" or "L" indication on the upper half of the LCD
display. "H" means 50 mW output. "L" means 10 mW output.
12
(GB)
AF RF BATT
If you want to change the RF output power, proceed the
following steps.
1
Set the unit to Setting mode.
2
To change the setting from "H" to "L" (or vice versa),
press the SET button until "Po: H" ( or "Po: L" )
appears on the lower half of the display.
3
Press the + or – button to change the RF power output.
AF RF BATT
4
Once the desired indication appears, set the POWER
switch to the off position to release Setting mode, or
press the SET button to continue operations in Setting
mode.
The next time you turn on the transmitter (by setting the
POWER switch to ON), the transmitter enters Transmit
mode with the RF output power selected.
– button
AF RF BATT
+ button