Specific Safety Rules - ENAR BOXEL 215 Manual De Instrucciones

MAINTAIN tool with care. KEEP cutting tools sharp and clean.
CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation. If damaged, have the tool serviced before using again.
USE only accessories that are recommended by the manufacturer for your model.
SERVICE
Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.

SPECIFIC SAFETY RULES

1 For the proper operation of the converter, MAKE SURE that operators have been instructed in the
proper management of this machine.
2 The converter SHOULD ONLY BE USED in the specific jobs for with it the help of this manual.
3 Before connecting the converter to the electrical system, MAKE SURE that the voltage and
frequency coincide with the ones stated in the characteristics equipment plate, located in the top part
of the plastic housing.
4 ENSURE that all frame screws are tight before starting work.
5 The motor plug should not be used to start or stop the equipment.
6 The electrical feeding cable should not be used to remove the plug from the socket.
7 Protect the electrical feeding cable against heat, oil or sharp edges.
8 DO NOT WORK CLOSE to flammable liquids or in areas exposed to flammable gases.
9 TO AVOID the flattening of the cable by heavy machinery with could cause breakage.
10 Do not permit untrained personnel to operate the motor or connexion.
11 Maintain free ventilation of air.
en
12 Keep the converter clean and dry.
13 Make sure that the electrical cable is with the proper section and functioning properly (see section
4.3)
14 Before doing any work of maintenance, disconnect the motor from the electrical system.
15 When connecting to a generator, make sure that the out tension and frequency is stable , right
and has the proper power. (the converter feeding voltage should not vary than +/- 5% as stated on
the converter plate.
16 The level of acoustic pressure is less than 70 dB. Proper protective equipment should be used
when the noise level gets to be more than 70 dB.
17 Respect the maximum number of vibrating pokers that can be connected to the converter.
18 Avoid having the converter working unloaded during long periods of time. The vibrating pokers
should not be working out of concrete. Switch on the poker before starting working an disconnecting
them immediately after finishing the vibrating operation.
19 During breaks at work, the operator must turn off converter, unplug from the mains and let's NOT
it will not tip or fall.
20 The vibration level of the machine is not a cause of health risk. Check the acceleration on the
vibrators before using it.
21 Switch on needles always after converter is ON.
IN ADDITION, LOCAL COUNTRY STABLISHED ORDINANCES SHOULD BE RESPECTED.
ELECTRONIC FRECUENCY CONVERTERS
6
BOXEL 215 / 225 / 325