Installing/Removing The Battery Pack; Operating The Blower - EGO LB5750E Manual Del Operador

Soplador inalámbrido con acumulador de ion de litio de 56
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 33
APPLICATION
EN
You may use this product for the purposes listed below:
Clearing hard surfaces such as driveways and
walkways.
Keeping decks and driveways free from leaves and
pine needles.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse.
ASSEMBLING/REMOVING THE BLOWER TUBE
To Assemble (Fig. B)
Align the groove and push the tube onto the blower
housing until you hear a "click".
To Remove (Fig. C)
Press the tube-release button and pull the tube out.
ASSEMBLING/REMOVING THE BLOWER SPREAD
NOZZLE
To Assemble(Fig. D)
Align the groove in the spread nozzle with the tube
knob and push the nozzle onto the tube until it snaps
into place.
To Remove(Fig. E)
Press and hold the nozzle-release button to disengage
the latch, then pull the nozzle straight from the blower.

INSTALLING/REMOVING THE BATTERY PACK

NOTE:
For best performance, we recommend use of
the EGO 56V Battery BA2240E (4.0 Ah) or any EGO 56V
battery with higher capacity.
Charge before first use.
To Install (Fig. F)
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a "click".
To Remove (Fig. G)
Depress the battery-release button and pull the battery
pack out.
WARNING:
Always take care to note the location of
your feet, children, or pets when pressing the battery-re-
lease button. Serious injury could result if the battery
pack falls. NEVER remove the battery pack when in a high
location.
10
56 VOLT LITHIUM-ION CORDLESS BLOWER — LB5750E
STARTING/STOPPING THE BLOWER (Fig. H)
To Start
1. Depress the air-speed trigger and the blower will begin
to run.
2. To lock the blower on, move the air-speed-trigger lock
toward the back of the tool. The blower runs at higher
speeds as the lever is moved further back.
3. The air-speed-trigger lock can also be pulled back to
start the blower without needing to first depress the
air-speed trigger.
To Stop
1. If the air-speed-trigger lock lever is not engaged,
release the air-speed trigger to stop the blower.
2. If the air-speed-trigger lock is engaged, move the lever
to the OFF position to stop the blower.

OPERATING THE BLOWER

To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
center of a pile.
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when
water is available.
Conserve water by using power blowers instead
of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills,
porches, and gardens.
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
After using blowers or other equipment, clean up!
Dispose of debris properly.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido