OK. OCR 310 Manual Del Usuario página 29

18.
19.
20.
21.
22.
23.
24.
25.
IM_OCR 310 W_161123_V04_HR.indb 29
Refer all servicing to authorised service agent. Do not
attempt to repair the product yourself. Servicing is required
when the product has been damaged in any way, such
as the supply cord or plug are damaged, liquid has been
spilled, objects have fallen into the product, the enclosure
is damaged, the product has been exposed to rain or
moisture, does not operate normally, or has been dropped.
Before connecting the product to a socket outlet, make
sure the voltage indicated on the product corresponds to
your local mains.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or similarly qualified
person in order to avoid hazard.
Regularly check if the supply cord, product or extension
cable is defective. If found defective, do not put the product
into operation. Immediately pull the plug.
Place the supply cord and, if necessary, an appropriate
extension cable in such away that pulling or tripping over
it is impossible. Do not allow the supply cord to hang down
within easy reach.
Do not jam, bend or pull the supply cord over sharp edges.
The power plug is used as the disconnect device; the
disconnect device shall remain readily operable. To
completely disconnect the power input, disconnect the
mains plug.
The product may not function properly or not react to the
operation of any control due to electrostatic discharge.
Switch off and disconnect the product; reconnect after a
few seconds.
29
EN
23/11/16 5:02 PM