Bosch PLL 5 Instrucciones De Servicio página 21

Downloaded from Elcodis.com electronic components distributor
OBJ_BUCH-311-004.book Page 21 Wednesday, March 14, 2007 4:38 PM
Checking Horizontal/Vertical Lines with the Spirit Levels
(see figure E)
The measuring tool can be used as a contractors level for checking
horizontal or vertical lines, e.g., for the level set-up of a washer or a
refrigerator. Position the measuring tool with the aluminium support-
ing surface 8 facing against the surface to be checked. When posi-
tioning against horizontal surfaces, the aluminium supporting
surface 8 must face downward. When positioning against vertical
surfaces, the exit opening for the laser beam 9 must face upward.
Operating Instructions
Keep the adhesive tape strips 4 out of the reach of small
children. Children could mistake the strips with chewing gum.
Mounting to a Wall
Four fastening methods are available for fastening the wall holder to
different surfaces:
• Fastening with Adhesive Tape Strips (see figure F): With
the removable adhesive tape strips 4, the wall holder can be fas-
tened to sensitive or delicate sturctural materials without causing
damage to them. The structural surface must be straight, firm,
dry, grease-free and have a temperature of at least 15 °C . Pull
off one of the protective foils from an adhesive tape strip ( ) and
position the adhesive tape strip onto the back side of the wall
holder ( ) in such a manner that its end projects out. Pull off the
second protective foil ( ) and firmly press the wall holder with
the adhesive tape strip against the structural surface ( ) for at
least five seconds. To remove the wall holder, pull out the adhe-
sive tape strip by the projecting end slowly and as parallel as
possible to the structural surface ( ).
• Fastening with Pins (see figure G): With the pins 2 provided,
the wall holder can be fastened to drywall or wooden walls.
Insert the pins through the openings in the wall holder as shown
in the figure.
• Fastening with a Screw: Place the wall holder 1 via the opening
on the back side onto a screw that projects lightly out of the wall.
• Fastening with Adhesive Tape (see figure H): The wall holder
can also be fastened with commercially available adhesive tape
(not included in the delivery scope) as shown in the figure.
1 609 929 L40 • 14.3.07
English | 21