Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Turn the door over.
5.
Replace the cover plate (1) and the hinge pin (2) on top of the door, on the opposite side.
6.
Replace the screws (3) and the plate of the switch (4) at the bottom of the door.
7.
Replace the door stop (5) and the hinge pin (6) at the bottom of the door, on the opposite side.
TEMPERATURE
Make sure that the room temperature lies between 10°C and 26°C. If the temperature is higher or lower,
the performances of the appliance may be affected. The temperature may vary depending on whether the
bottles are on the upper, middle or lower racks and whether the inside lighting is on or not.
The standard temperature for the lower part is 14°C and for the upper part 8°C. You can adjust the
temperature using the control buttons. In case of a power cut, the standard temperatures will be used
again.
CONTROL PANEL
1
A: lower zone
B: upper zone
1.
Button to raise the temperature
2.
Button to lower the temperature
3.
Display
4.
On/off button of the light
5.
On/off button of the appliance
·
The desired temperature can be set using the buttons to raise or lower the temperature. (1+2) Pressing
these buttons, the temperature will change with 1°C each time you push the button.
·
The temperature of the lower part (10°C till 18°C) and the temperature of the upper part (5°C till
14°C) can be set separately with a minimum and maximum temperature difference. The lower part
24
DO918WK
2
3
A
2
5
6
1
2
3
B
1
4
5
Publicidad
Tabla de contenido
