Installing The Strainer - Conglom QK95R Manual Del Usuario

Installation (continued)

INSTALLING THE STRAINER

NOTE:
If you are installing a garbage disposer (not supplied), do not install the strainer.
- Position the drain (3) and the gasket (4) into the drain opening of the
sink . Silicone or plumbing putty may be used instead of the gasket (4) .
- Remove any major surface irregularities from around the bottom of the
drain opening .
- Fill both grooves of the bottom seal (5) with silicone sealant (not
supplied) .
- Push the bottom seal (5) with the groves against the bottom of the sink
such that it is evenly seated .
- Put a small bead of silicone around the flange of the lower strainer
body (6) .
- Press the lower strainer (6) body into the bottom seal (5) and secure
components with the strainer screw (2) .
- Tighten the strainer screw (2) until all gaps are eliminated and all the
components are tightly seated flat against each other.
- Wipe off excess sealant and allow it to cure as suggested by the
sealant manufacturer before connecting your plumbing .
- Insert the plastic flange (7) into the tail pipe (8), and secure them to
the lower strainer body (6) using the connecting nut (9) as indicated by
the manufacturer .
- Repeat these instructions for second strainer .
(Not supplied)
Silicone
9
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
1
2
3
4
A
5
6
7
8
9
4 3
A
5
6
Silicone
DRAIN INSTALLATION DETAIL
CONGLOMKB .COM
Silicone
Silicone