Publicidad
Idiomas disponibles
Idiomas disponibles
c. To reset the function: Press SELECT and START for 3 seconds, then quickly press any pedal
twice.
5) Foot pedals simulate analogue function in digital mode
The higher the flash frequency, the bigger the value change.
5. System requirements (PC):
1) Supports USB port.
2) Windows 98/ME/2000/XP/VISTA/7
3) DirectX 7.0 Version and up.
6. Programme installation (PC):
Programme installation under Windows98/Me/Window2000/WinXP /Vista/7
1) Enter Windows
according to the indication;
2) Start
Control Panel
3) Insert the plug of the steering wheel into the PC's USB port
according to instructions
driving system automatically
7. Testing the Steering Wheel:
1) Enter "Test Page"
A. Testing wheel directions:
a. Turn the wheel left and right, the corresponding Axis X will move left and right.
b. When the "+" cursor is not in the centre of the X/Y Axis block, please enter the Calibration
Function for correction.
B. Testing the buttons from "1" to "10":
Press any button from 1 to 10 on the wheel, and the corresponding button in the test page will
turn red.
C. Testing the directional buttons:
Digital mode: Press the direction button's 8 directions (up, down, left, right plus angle). The
interface's "X/Y axis" block has corresponding direction indications.
Analogue mode: Press the direction button's 8 directions (up, down, left, right). The interface's
"Pov info" block has corresponding direction arrow indications.
2) Enter the "Calibration Function" for correction
The calibration is only used under the analogue mode (Led Indicator is on) while "+" cursor is not
in the centre position. Please press "Default" first, then "set" to calibrate.
3) Enter the "Effect Page" to test the vibration of the motor:
In digital mode, press the right and left directions of the directional button. The corresponding right
motor vibrates. Press the up and down directions of the directional button. The corresponding right
motor vibrates. Now the motor indication light will switch on.
8. Troubleshooting (PC):
1) The controller does not work normally after installing the software and hardware.
a. Check whether the controller's link cable is correctly connected to the PC.
b. Make sure that the status indication of the option "Game Port Controller" for "Game Controller"
under "Control Panel" is "Confirmation", and "Game Port controller" for checking the game
controller's "ID" is "1".
c. Make sure the controller's I/O settings is working correctly along the other peripheral settings.
d. Restart the computer if the controller still does not work normally.
2) "LS-USBMX1/2/3 Steering Wheel W/Vibration" driving programme cannot be installed or
the controller test shows no response after installing it.
DirectX's version requires a version of 7.0 and up.
Insert disc
Double click "SETUP", and set up the driving system
Game Controller;
the PC will find "LS-USBMX1/2/3 Steering Wheel w/vibration"
Assign.
4
Install the driving system
Publicidad
