Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly & Set-Up
Contents of Carton
•
Chipper/Shredder Vacuum (1)
•
Upper and Lower Handle (1)
•
Bag (1)
Assembly
NOTE:
This unit is shipped without gasoline or oil in
the engine. Fill up gasoline and oil as instructed in
the accompanying engine manual BEFORE operating
your chipper shredder vacuum.
Handle
1.
Remove the hairpin clips from the handle
brackets and the carriage screws and wing
nuts from the lower handle.
a.
Place the bottom holes in lower
handle over the pins on the handle
brackets with notch in handle pointing
downwards and secure with hairpin
clips. See Figure 3-1.
b
a
Figure 3-1
b.
Insert carriage screws through upper
hole in lower handle from the inside
and secure with wing nuts. See Figure
3-1.
•
Operator's Manual (1)
•
Hose Assembly (1)
•
Bottle of Oil (1)
2.
Unfold the upper handle until it aligns with
lower handle. Make sure the rope guide is on
the right side of upper handle. See A in Figure
3-2.
b
3.
Secure the two handles by tightening the star
knobs (carriage bolts must be seated properly
b
into the handle). See B in Figure 3-2.
4.
Loosen the wing nut that secures the rope
guide to the right side of the upper handle.
a.
Slowly pull starter rope out of engine.
b.
Slip the starter rope into the rope
guide. See Figure 3-3.
b
c.
Tighten the wing nut.
a
Figure 3-2
a
c
Figure 3-3
•
Engine Operator's Manual (1)
•
Safety Glasses (1)
•
Hose Extension (1)
Hose Assembly
1.
Slide hose adapter of hose assembly into the
base adapter located on the left front of the
chipper shredder vacuum. See A in Figure 3-4.
A
Align Pin with
this Hole
Figure 3-4
2.
Pull spring loaded pin out on the base and
align pin with the first hole (closest to the
end of the tube) in the hose adapter. See B in
Figure 3-4.
3.
Release the pin to lock the hose in place.
4.
Lay hose tubing in curved end of hose handle
next to chipper chute and into hose cradle (if
applicable). See A and B in Figure 3-5.
c
a
b†
† If Applicable
Figure 3-5
5.
Snap the hose handle first into the upper hose
handle bracket and then into the lower hose
handle bracket. See C in Figure 3-5.
3
B
5
Publicidad
Solución de problemas
