1.0 Introduction - BONAIRE Durango Serie Manual Del Propietário

I I
NSTALLATION NSTRUCTIONS

1.0 Introduction

General Information
Thank you for purchasing a quality Bonaire Evaporative Cooler. We care about your safety and would
ask you to spend a few minutes reading these simple instructions before operating this product.
Safety!
Read carefully all of these instructions prior to operating the unit.

Read and Save these Instructions. Do not throw these Instructions away.
 WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
 Use this unit only in the manner intended by the manufacturer. Interference with and operation of
this cooler in any manner not prescribed by these instructions could cause a safety issue and WILL
void any warranty. If you have any questions, contact the manufacturer.
 Before servicing or cleaning the unit, switch power off at the service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag,
to the service panel.
 Installation work and electrical wiring must be done by qualified person(s) in accordance with all
applicable codes and standards, including fire-rated construction.
 Do not use cooler on uneven or unstable surfaces.
 When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden
utilities.
 Evaporative coolers must always be vented to the outdoors.
 Use only with a 115V, 60Hz, 1 phase electrical supply.
 Motor and pump have a grounded, molded plug and an automatic thermal overload which will stop
the motor operation if it overheats. The motor will restart again when it cools down.
 The molded pump receptacle is for the grounded evaporative cooler pump only. Do not plug
anything else into this receptacle.
 Do not alter or modify this cooler.
 Do not allow children to operate or service this cooler.
 WARNING: To reduce the risk of fire or electric shock, do not use this product with any solid state
speed control device.
 Use only qualified electricians for replacement or servicing of switches, or electrical motors and
components in this cooler.
 Always turn off power and unplug the fan motor and pump inside the cooler before installation or
maintenance and cleaning. More than one disconnect switch may be required to de-energise the
equipment for servicing
 CAUTION: This unit has an unguarded impeller. Do not use in locations readily accessible to
people or animals.
 Wiring shall be in accordance to the National Electrical Code, ANSI/NFPA 70
 A 'wet cardboard' smell may be noticeable at start-up but will dissipate after a few hours of running.
 IMPORTANT: When refitting screws use HAND TOOLS ONLY.
DO NO USE POWER TOOLS to tighten screws as incorrect torque setting WILL STRIP the hole
thread.
3