Tabla de contenido
Publicidad
T T echnical description according to EN 60601-1-2
The Memmert steriliser type S.. is intended for use in the electromagnetic environment specified below. The
customer or user of the steriliser type S.. should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Volage fluctuations / flicker
emissions IEC 61000-3-3
NOTE
The system impedance at the interface point according to IEC 61000-3-11 should not ecxeed
0.248+j0.155 Ohm resp. Zsys = 0.29 Ohm.
The Memmert steriliser type S.. is intended for use in the electromagnetic environment specified below. The
customer or user of the steriliser type S.. should assure that it is used in such an environment.
Immunity
test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
tranient / burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and
voltage variations
on power supply
input lines
IEC 61000-4-11
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
U
NOTE
is the mains voltage prior to application of the test level.
T
D33342 | Fecha: 12/2019
Guidance and manufacturer's declaration – electromagnetic emissions
Compliance
Group 1
Class B
Class A
Complies
Guidance and manufacturer's declaration – electromagnetic immunity
IEC 60601
test level
6 kV contact
8 kV air
2 kV for power
supply lines
supply lines
1 kV for input /
output lines
output lines
1 kV differential
mode
mode
2 kV common
mode
mode
U
< 5 %
< 5 %
T
U
(>95 % dip in
)
(>95 % dip in
T
for 0,5 cycle
for 0,5 cycle
U
40 %
40 %
T
U
(60 % dip in
)
(60 % dip in
T
for 5 cycles
for 5 cycles
U
70 %
70 %
T
U
(30 % dip in
)
(30 % dip in
T
for 25 cycles
for 25 cycles
U
< 5 %
< 5 %
T
U
(>95 % dip in
)
(>95 % dip in
T
for 5 s
for 5 s
3 A/m
Not applicable
Electromagnetic environment - guidance
The steriliser type S.. uses RF energy only for ist internal
function. Therefore, ist RF emissions are very low and are
not likely to cause interference in nearby electronic
equipment.
The sterilier type S.. is suitable for use in all
establishments, including domestic establishments and
those directly connected to the public low-voltage power
supply network that supplies buildings used for domestic
purposes.
Compliance
Electromagnetic enviroment –
level
6 kV contact
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
8 kV air
should be at least 30 %.
2 kV for power
Mains power quality should be that of a
typical commercial or hospital
enviroment.
1 kV for input /
1 kV differential
Mains power quality should be that of a
typical commercial or hospital
enviroment.
2 kV common
U
Mains power quality should be that of a
T
U
)
typical commercial or hospital
T
enviroment.
U
If the user of the steriliser type S..
T
U
)
requires continued operation during
T
power mains interruptions, it is
recommended that the steriliser type S..
U
will be powered from an uninterruptible
T
U
)
power supply.
T
U
T
U
)
T
guidance
Anhang
63
Publicidad
Tabla de contenido
