Selector Switch - PIONEER DJ DJM-250MK2 Manual De Instrucciones

7 TRIM control (page 10 )
Adjust the volume from each channel.
8 ISO (HI, MID, LOW) controls (page 10 )
Adjust the sound quality of the respective channels.
9 Master Level indicator (page 10 )
It shows the volume from the MASTER output.
When the volume is too loud, the [CLIP] indicator flashes. In this
case, turn down the volume.
— Slow flashing: sound will become distorted.
— Fast flashing: sound is distorted.
a Channel Level indicator (page 10 )
It shows the volume before passing the channel fader.
b STANDBY indicator
This indicator is lit when the unit is in the standby state.
c COLOR control
Change the parameters of the SOUND COLOR FX of the different
channels.
d FILTER button
Turn on/off the SOUND COLOR FX effects.
— WAKE UP: Press this button to cancel the standby state.
e CUE button (page 10 )
Press the [CUE] button for the channel you want to monitor.
f Channel Fader (page 10 )
Adjust the volume of each channel.
g CROSS F.CURVE (THRU,
(page 10 )
This switches the cross fader curve characteristics.
h CROSS F. REVERSE switch (page 10)
Turn on/off the cross fader reverse function.
i Cross fader (page 10 )
Sound outputs following the curve selected by the [CROSS F.CURVE]

selector switch.

j HEADPHONES LEVEL control (page 10 )
Adjust the level of audio signals output from the headphones.
k HEADPHONES MIXING control (page 10 )
Adjust the monitor volume balance of the sound of channels for
which the [CUE] button is pressed and the sound of the [MASTER]
channel.
l MASTER LEVEL control (page 10 )
Adjust the level of audio signals from the [MASTER1] or [MASTER2]
output.
Do not pull on the channel fader and cross fader knobs with excessive
force. The knobs have a structure by which they cannot be pulled off
easily. Pulling the knobs strongly may result in damaging the unit.
, ) selector switch
7
En