Sveon SConnect Serie Manual De Usuario página 16

Verification of installation
If you want to verify if the installation has been done properly you can use any available service from different official web-
sites, like the Polie official website as shown:
- Click on "Check your points"
- Click on the option marked with an orange square:
- Then the DNIe PIN will be required:
For further information please visit the official website: www.dnielectronico.es.
10. Card Reader Uninstallation
We suggest you disconnect the device by clicking on "Remove hadrware sa-
fety". Right clicking over the device icon in the window bar and then select
"Remove hardware safely". Select the device and then click on "Stop". A con-
firmation message will appear when you could unplug the device.
11. FAQs
The certificate doesn´t work when the DNIe is inserted in its card reader slot
Please make sure the DNIe is correctly inserted in its slot. Then, check if the card reader works properly by selecting the
option "Test Reader" in the installation main menu of the device.
This window will appear. If the card reader works properly, the following message will appear onscreen: "Smart Card Re-
ader is working correctly".
If this message doesn´t appear, please install again the device following carefully all the installation steps.
After installing again the device it should work properly. If it doesn´t, please contact with our Technical Support.
SCT010 User Guide
Index
1. Welcome
2. Features
3. Technical Specifications
4. System Requirements
5. Content
6. Hardware
7. Installation
8. DNIe software installation (WinXP)
9. DNIe software installation (WinVista/7)
10. Uninstallation
11. FAQs
12. Warning: disposal of waste batteries
English 16