Control Panel - Tribest Dynapro DPS-1050 Manual De Uso

1. On/Off Switch
The On/Off (or Power) Switch is located on the lower right-hand side of the machine. The
On/Off Switch controls the power to the machine.
2. LCD Display
Machine Status Display
3. Variable Speed Dial & Start/Pause Switch
In the manual timer mode by turning the knob and adjust the rpm & setting and press the
knob and the start / stop function. For safety reasons, if there is no speed dial operation in
manual mode, the operation will stop after 1 minute (built-in function).
4. Variable Time Dial & Mode Switch
Press the knob to switch between manual and timer mode, the timer mode by turning the
knob to setting the rpm
5. Blend Preset Button
Press the Blend Preset Button to automatically blend for 30 seconds. Each press of the Blend
Preset Button will add 30 seconds to the total blending time. Ex.: press the Blend Preset Button
3 times to blend for a minute and a half (30 sec. + 30 sec. +30 sec. = 90 sec.). The timer will
resume 00:00 when start/pause knob is pressed.
6. Pulse Preset Button
Press the Pulse Preset Button to automatically pulse for 30 seconds. Each press of the Pulse
Preset Button will add 30 seconds to the total pulsing time. Ex.: press the Pulse Preset Button 3
times to pulse for a minute and a half (30 sec. + 30 sec. +30 sec. = 90 sec.). The timer will
resume 00:00 when start/pause knob is pressed.
7. Combo Preset Button
Press the Combo Preset Button to automatically pulse three times before blending for 30
seconds. Each press of the Combo Preset Button will add 30 seconds to the total blending
time. Ex.: press the Combo Preset Button 3 times to blend for a minute and a half (30 sec.
+ 30 sec. + 30 sec. = 90 sec.). The timer will resume 00:00 when start/pause knob is pressed.
8. Status LED
Manual mode: Blue, Timer mode: Red, Auto mode: Violet
2
3
=

CONTROL PANEL

=
4
=
=
5
=
=
6
1
7
=
11