Fein FSC1.7 Serie Instrucciones De Uso página 14

OBJ_BUCH-0000000208-004.book Page 14 Thursday, August 24, 2017 10:30 AM
en
14
Changing the tool
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
For all work or when changing
CAUTION
application tools, always wear
protective gloves. Danger of injury from the
sharp edges of the application tools. Applica-
tion tools can become very hot while work-
ing. Danger of burns!
Before using, sharpen used and even new cut-
ter blades with a sharpening stone.
The symptom for worn blades is a clearly
increased feed force at lower working prog-
ress.
The application tool can be offset in 30° steps
and fastened in the most favorable working
position.
When changing application
CAUTION
tools with sharp cutting
edges, use cover 3 21 74 011 00 0 to protect
yourself against hand/arm injuries.
Mounting application tools
(FSC1.7 (**)) (figure 3).
Screw out the fastening element.
Clean the tool holder, the application tool and
the fastening element.
Insert the application tool accurately into the
star-shaped tool holder. Pay attention that the
application tool is mounted flush.
Screw in the fastening element to the stop.
Do not switch the power tool
CAUTION
on while the clamping lever is
open. Otherwise there is danger of crushes or
contusions to the hand and fingers.
Do not overload the power
CAUTION
tool. Overloading increases
the vibration on the power-tool housing and
can cause the power tool to become very hot.
Danger of injury.
For all work or when changing application
tools, always wear protective gloves.
Danger of injury from the sharp edges of the
application tools. Application tools can
become very hot while working. Danger of
burns!
Fastening element
Fig. 3
1.
2.
Fastening element
4.
3.
Application tool
5.