Setting The Temperature; Steam Ironing - Euroflex IB 35 Perfect Plus Manual De Instrucciones

Warning: The steam emitted is very hot. Danger of scalding!
Note: The appliance may give out some smoke when using it for the fi rst time. It is a technical phenom-
enon that will cease after a short while.
Note:
- After turning the appliance on or after a long pause, direct the fi rst steam jet toward the air or toward
a piece of cloth but not on the garment to be ironed, so that any condensed water still in the iron may
be expelled without staining the garment.
- After the fi rst steam jet the pressure slows down rapidly. It is not a fault. This is due to the emission
of the air that entered the boiler during the fi lling.
After ironing
- Leave the ironing board on for 10 minutes to dry any condensate.
- Turn the ironing board off (on/off switch (7)).
- Pull the plug out of the mains socket.
- Let the appliance completely cool down.
- Remove the iron cord support (8).
- Put the iron on the iron-rest mat (2).
- Acting on the height adjustment lever (13) lower the ironing board.
Note: do not entangle the power cord.
- It is possible to place the ironing board upright with the steam generating unit downward.
- Always make sure the ironing board do not slip or overturns. Store the appliance in a dry place away
from the reach of children.

5. Setting the temperature

To steam-iron, always set the iron temperature control (5) on steam position, otherwise the temperature
is too low, the steam condenses and water may drip from the soleplate. The steam position is in the
sector between "••" e "•••". Within this sector it is possible to steam-iron any fabric.
Note: the ironing symbols on the garment labels refers to dry ironing only (see page 14) and shall not
be observed when steam ironing. In case of very delicate fabrics it is recommended to try ironing in a
hidden part of the garment or place a piece of cloth on the garment.
Iron temperature control
6. Steam-ironing
- As soon as the green "steam ready" light (21) comes on and the iron warming-up light on the iron (11)
goes off, the active ironing board is ready for use.
- Push the "steam" button (4) on the iron.
Warning: The steam emitted is very hot.
Interruption of the steam emission
To interrupt the emission of steam simply release the "steam" button (4) on the iron. When you are not
ironing place the iron on the iron-rest mat (2).
25