Publicidad
Idiomas disponibles
Idiomas disponibles
D00048EN - v1
3 - INSTALLATION AND CONNECTIONS
Attach to the main profile of the operator using the screws
supplied. Pass the cables through the bottom of the
receiver. Connect the power cables to the terminals marked
in the mother board, as indicated.
Visio
Jumper position
(to 12V)
Bravo
Activa
RECEIVER GRF-R - INSTRUCTIONS MANUAL
4 – OPERATING
The pilot lights are activated every 5 seconds to indicate
the correct supply of power to the equipment. Upon
receiving a code, the receiver checks whether it is in its
memory, activating the corresponding relay. The relay
activation mode is selected in either impulse or ON/OFF
using the Imp/Bies jumper (only with the relay 2). For
adjustment of relay 1, see manual of the programming tool.
5 - PROGRAMMING
5.1 - MANUAL PROGRAMMING
Press the receiver programming button for 1 sec. and an
acoustic signal will be heard. The receiver will enter
standard programming (see table). If the receiver
programming button is held pressed down, the receiver Hill
enter special programming, cyclically passing from one
configuration
to
the
configuration for the transmitter to be registered has been
chosen, send the code to be programmed by pressing the
transmitter. Every time a transmitter is programmed, the
receiver will issue an acoustic signal for 0.5 sec. After 10
seconds without programming or pressing the first two
transmitter buttons, the receiver will exit programming
mode, issuing two acoustic signals of 1 sec. If upon
programming a transmitter the receiver memory is full, it will
issue 7 acoustic signals of 0.5 sec. and exit programming.
Configuration of transmitter program-
ming in the receiver.
Standard Programming (default option,
the receiver is always configured on pluri-channel)
The relays are activated 1st relay by
channel 1
and 2nd relay by channel 2 (3rd relay
by channel 1
and 4th relay by channel 2)
Special programming
By pressing any transmitter channel,
relay 1 on the receiver will be acti-
vated
By pressing any transmitter channel,
relay 2 on the receiver will be acti-
vated
By pressing any transmitter channel,
the two relays
will be activated at the same time*
8
next.
Once the
programming
Led R1
Led R2
Flashing
Flashing
ON
OFF
OFF
ON
ON
ON
Publicidad
