Initial Operation; Working Advice - Bosch GLI 10,8 V-LI Professional Manual Original

OBJ_BUCH-1072-006.book Page 15 Tuesday, March 3, 2015 10:27 AM
The lithium-ion battery can be charged at any time without reducing its service life. In-
terrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
 Do not continue to press the On/Off switch after the cordless worklight has
been automatically switched off. The battery can be damaged.
To remove the battery 3, press the battery unlocking button 4 and pull the battery out
of the cordless worklight toward the rear. Do not exert any force.
Observe the notes for disposal.
Operation

Initial Operation

Inserting the battery
Insert the charged battery 3 into the handle until it can be felt to engage and faces
flush against the handle.
Switching On and Off
 The cordless worklight produces a light beam that emerges from the lamp
head 1.
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
To save energy, only switch the cordless worklight on when using it.
Protection Against Deep Discharging
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.

Working Advice

Belt Clip (see figure B)
With the belt clip 5, the cordless worklight, as an example, can be hooked to a belt.
The user has both hands free and the cordless worklight is always at hand.
Bosch Power Tools
English | 15
1 609 92A 183 | (3.3.15)