DeWalt DWX726 Manual De Instrucciones página 8

2. Using a crescent wrench or 1/2 inch open end wrench, tighten the
screw securely.
3. Repeat for the other cord wrap.
FIG. 11
X
ATTACHING THE TOOL (FIG. 13–16)
WARNING: STABILITY HAZARD. Refer to your tool manufacturer's
instructions regarding the securing of your miter saw or planer to a
stand or supporting surface. Secure the tool according to both the
instructions in this manual and those in your tool manufacturer's
manual before operating. Failure to heed these warnings may result in
serious personal injury and serious damage to the tool.
WARNING: To reduce the risk of injury, turn miter saw or
planer off, disconnect the tool from the power source before
assembling the miter saw or planer to the stand. An accidental
start-up can cause injury.
1. Loosen the 6 rail screws (AA) with the supplied hex wrench.
Remove the mounting bolts/flat washers (BB) from the mounting
rails.
FIG. 13
FIG. 12
Z
X
2. Slide the mounting rails (A) to fit the width of the tool. Ensure the
mounting slots align the with holes in the tool's feet.
WARNING: Planers MUST be mounted in the orientation shown in
Figure 16.
3. Place miter saw or planer on the mounting rails (A). Center the tool,
both forward and backward and side to side, on the stand.
4. Ensure the mounting holes (CC) in the tool's feet align with the rail
slots (DD) and the captured nuts (EE) located in the mounting rails.
5. Once the two rails are in place, tighten the rail screws (AA)
loosened in STEP 1.
6. Insert the mounting bolts/flat washers (BB) (removed in STEP 1)
through each of the tool's feet into the captured nut (EE). Tighten
securely.
IMPORTANT: The miter saw or planer MUST be positioned so the tool
is bolted squarely to the mounting rails. If this is not possible, please
call 1-800-4-D
6
AA
BB
A
BB
AA
WALT (1-800-433-9258) for technical assistance.
E