Install The Supports; Install The Sink - Conglom QK51R Manual Del Usuario

Installation (continued)

INSTALL THE SUPPORTS

NOTE:
Installation method used by your professional installer may differ from that
described below depending on your cabinet and installation type.
Temporarily install 2"x4" supports on each side to test fit the sink.
Top supports should be aligned with the installation line. Test fit
the sink to ensure it is level and rests at the desired installation
height . Make adjustments as needed .
Ensure that the support structure allows for unobstructed
installation of the drain, faucet, water supply lines, and a garbage
disposal (if required) .
Once you are satisfied with support structure, secure it to your
cabinet using construction adhesive and wood screws . Double
check the alignment of your support structure to ensure nothing
has shifted .

INSTALL THE SINK

Test fit the sink again. Ensure the sink is level from side to side and
front to back . Entire weight of the sink should be resting securely
on the support structure . Shim and adjust as needed .
Secure the sink to the support structure and countertop using
silicone sealant .
Wipe away any excess silicone with an appropriate solvent . For
best results, allow the sealant to fully cure before proceeding .
QK51R
Secure supports using
construction adjesive
and wood screws
Seal and secure
sink using
silicone sealant
8