Unpacking Instruction; Power Supply; Front Panel - Vonyx STM3030 Manual De Instrucciones

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving of the equipment, carefully unpack the carton, check the contents to ensure that all parts
are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection
if any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that an equipment must be returned to the factory, it is important that the equipment be returned in the
original factory box and packing.
If the equipment has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
POWERSUPPLY
On the label on the backside of the equipment is indicated on this type of power supply must be connected. Check that the
mains voltage corresponds to this, all other voltages than specified, the equipment can be irreparably damaged. The equipment
must also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
OPERATION
1.
POWER ON - Once you have made all the equipment connections to your DJ-mixer, press the POWER (11). The power
will turn on and the POWER LED (10) will glow RED.
2.
CHANNEL 1 - SWITCH (4) allows you to select the PHONO 1/LINE 1 (18) jack to input phono or line level. The CHANNEL
SLIDE (5) controls the output level of this channel.
3.
CHANNEL 2 - SWITCH (6) allows you to select the PHONO 2/LINE 2 (19) jack to input phono or line level. The CHANNEL
SLIDE (7) controls the output level of this channel.
4.
CHANNEL 3 - SWITCH (8) allows you to select the MP3 OR LINE 3 (20) jack to input phono or line level. The CHANNEL
SLIDE (9) controls the output level of this channel.
5.
CROSSFADER - The CROSSFADER (13) allows you to the Mixing CH1/CH2 source into another.
6.
MIC – Connect the microphone with a 1/4" connector at the rear panel (16 and 17). The volume of microphone 1 and 2 can
be controlled with the microphone volume control (2).
7.
TALKOVER (3) - The purpose of the talkover section is to allow the program playing to be muted so that the mic can be
heard above the music. When you press the SWITCH, the talk over will be on and the volume of all sources except the Mic
inputs are lowered by 12dB. The MIC VOL (2) allow you to control the level of MIC1/MIC2.
8.
PHONE - Connect your headphones to the headphones socket
for monitoring with the Cue switch(1). With this knob PHONE(14), you can adjust the headphones volume
9.
VU-Meter - The VU-meter (12) indicates either the MASTER output left and right levels.
10.
MP3 PLAYER (15) - SD / USB / BT-Player. See explanation later.

FRONT PANEL

4
(22)
and select the desired channel (channel 1-3 or MIC)