Eco mode:
The lawn mower features an
eco mode, which improves its
energy efficiency and therefore
its cutting performance.
Function:
The speed of the electric motor is lowered
automatically when less power is required.
If greater power is required, the motor
speed is increased again within a fraction
of a second.
9.3 Working area for operator
● For safety reasons, the operator
must stay within the working area
behind the handlebar when the motor is
running. Always observe the safety
distance provided by the handlebar.
● The lawn mower must only be operated
by one person. Other persons must
keep out of the danger area. (
9.4 Correct motor load
Do not switch on the lawn mower in tall
grass. Select a higher cutting height
setting if the motor is difficult to start.
The lawn mower load must never cause
the motor speed to drop significantly.
If the speed drops when mowing tall grass,
select a higher cutting height setting
and/or reduce the rate of feed.
The motor speed is lowered
automatically when less power is
required. (
9.2)
0478 131 9841 B - EN
9.5 If the mowing blade blocks
Switch off the motor immediately and
disconnect the safety plug. Then eliminate
the cause of the fault.
9.6 Thermal motor overload protection
The electronics switch off the motor if it
becomes overloaded during operation.
Three red LEDs in the battery illuminate if
a thermal overload occurs. (
Causes for an overload:
15
– blunt mowing blade
– mowing excessively high grass or
cutting height adjusted too low
– excessive rate of feed
– inadequate cleaning of the cooling air
guide (inlet slots)
4.)
Recommencing operation
Resume normal operation of the machine
following a cooling period of up to 10 min
(depending on the ambient temperature).
(
11.2)
10. Safety devices
The machine is equipped with several
safety devices for safe operation and for
the prevention of improper use.
Risk of injury!
If a safety device is found to be
defective, the machine must not be
operated. Consult a specialist
dealer; STIHL recommends STIHL
specialist dealers.
10.1 Safety plug
The motor can only be switched on when
the safety plug is inserted (
10.2 Safety devices
The lawn mower is equipped with safety
devices, which prevent inadvertent contact
with the mowing blade and with ejected
clippings.
7.5)
These include the housing, discharge flap,
grass catcher box and correctly installed
handlebar.
10.3 Two-hand operation
The motor can only be switched on by
pressing and holding the ON button with
the right hand and then pulling the
motorstop lever to the handlebar with the
left hand.
10.4 Run-down brake
When the motorstop lever is released, the
mowing blade comes to a complete
standstill in less than three seconds.
An integrated run-down brake shortens the
run-down time until the blade stops.
Measuring run-down time
Following motor start-up, the blade rotates
and a wind noise is audible. The run-down
time corresponds to the duration of the
wind noise after the motor stops. This can
be measured using a stopwatch.
8.1).
21