Receiver Operation - BoomToneDJ UHF-290d Manual De Instrucciones

RECEIVER OPERATION

11
IR
1 2 3 4 5
• Pull out the antennas (11, 12), make sure they are perpendicular to the receiver
• Connect the power:
Connect the power cable to the DC socket (16) of the Receiver, make sure the adaptor is
suitable before using the receiver
• Connect the audio cable:
Mix output: connect the audio cable (attached) to the MIX OUT socket (13) while the other side
is connected to the unbalanced microphone input of the mixing console or the amplifier.
• Balance Output:
Connect the balance audio cable (not included) to the BALANCE socket (14, 15) while the
other side is connected to the balanced microphone input of the mixing console or the ampli-
fier.
• Connect the USB charging cable:
Connect the charge cable (attached) to the USB socket (17) while the other side is connected
to the handheld microphone.
• Turn on the power button (1), LCD displays (5, 7) are lighting, receiver is in working status.
Note: Before turning on the Receiver, turn the volume control knobs (2, 10) to the minimum
volume, and adjust the volume as needed when the receiver is working.
12
IR
IR
LOCK
6 7 8 9 10
13 14 15 16 17
19