Installing The Hard Disk Drive - König Electronic SEC-DVRMON30 Manual De Uso

15" Monitor with DVR
Short Description Guide
Note: This is a short description guide for the SEC-DVRMON30. For full details on how to use
the SEC-DVRMON30, refer to the advanced English manual.

Installing the Hard Disk Drive:

Open the hard disk drive compartment with the 4 screws at the back of the monitor and take out the
holder. Install the hard disk drive in the holder and fix it to the holder with the 4 screws (supplied with
the hard disk drive). Connect the power and data connector to the hard disk drive. Replace the holder in
the compartment and fix the holder again with the 4 screws.
1. Power connector
2. Data connector
Before you can record onto your HDD it should be formatted by the DVR system,
as standard PC formatting is not compatible. It can be done in the Maintenance
Tab of the Tool Bar Main Menu. Please refer to Section 7.5.3 HDD Management of
the English manual for a detailed description of this process. Depending on the
size of your HDD, the formatting process can take several minutes.
Top Panel Description:
Power
Function: Description:
POWER Turn on / off the LCD monitor. This only turns of the monitor, not the system.
MENU/ENTER Press the key to configure the LCD monitor.
RIGHT/+ Move the parameters on the screen or increase value.
LEFT/- Move the parameters on the screen or reduce value.
AUTO/ESC Press the key to exit the configuration of the LCD monitor.
ENGLISH
Menu/Enter
Left/-
2
1
2
Right/+
Auto/ESC