Dometic PERFECTVIEW M9LQ Instrucciones De Montaje página 20

Installing the LCD monitor
Connecting control cables for additional cameras
The control cables are used as a signal cable for the activation of a side camera when the indicator
is flashing, for example.
➤ If the monitor is to be activated e.g. when the indicator is flashing, connect the following
control cable to a positive cable of the indicator:
– blue cable (12) for CAMERA RIGHT ( RIGHT video source) e.g. to the right indicator cable
– white cable (13) for CAMERA LEFT ( LEFT video source) e.g. to the left indicator cable
I
NOTE
If voltage is present in the control cable, the respective CAMERA RIGHT video input or
CAMERA LEFT video input is activated.
Up to fours cameras can be connected. These can be displayed individually through the control
cable. For example, the monitor can display a four split screen by default and individual screens
with control signal.
Connecting the cameras
➤ Connect the CAMERA BACK socket (5) of the connection cable with the plug of the BACK
video source (e.g. reversing camera).
➤ Connect the CAMERA RIGHT socket (6) of the connection cable with the plug of the RIGHT
video source (e.g. side camera).
➤ Connect the CAMERA LEFT socket (7) of the connection cable with the plug of the LEFT video
source (e.g. side camera).
➤ Connect the CAMERA FRONT socket (8) of the connection cable with the plug of the FRONT
video source (e.g. front camera).
I
NOTE
Observe the power consumption of the video system. The cameras are equipped with
heaters. A maximum current of 3 A can flow (cameras in heating mode). Use a
disconnector switch for direct connection to the battery. This allows you to disconnect
the video system from the battery easily if you are no longer using the vehicle.
Connecting the split screen control cable
➤ Connect the SPLIT control cable to a 10 – 32 V voltage signal which will activate the split
screen.
The split screen shows two cameras, which can be set in the "Trigger setup" menu at "Split
screen".
20
M9LQ
EN