Installing The Monitor - Dometic M 55L AHD Instrucciones De Montaje

M55L AHD, M75L AHD
7.2

Installing the monitor

!
CAUTION! Beware of injury
Select the location of the monitor so that it cannot injure the passengers in the vehicle
under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following installation instructions:
Select an installation location that provides an unobstructed view of the monitor (fig. 6 and
•
fig. 7, page 3).
•
Never install the monitor in areas where your head could hit it or in the airbag deployment path.
This could cause injury if the airbag opens.
The monitor must not impair your vision when driving (fig. 8, page 4).
•
•
The installation location should be flat.
•
Check that there is sufficient space underneath the installation location to attach the washers
and nuts.
•
Check beforehand that there is sufficient space on the other side for the drill head to come out
(fig. 2, page 3).
•
Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger washers or
plates).
•
Make sure you can lay the connection cable to the monitor.
Choosing the installation location (fig. a, page 6)
➤ Place the monitor on the monitor bracket.
➤ Position the monitor and the attached monitor bracket provisionally.
➤ Mark the outlines of the corners of the support base on the dashboard.
➤ Take the monitor off the monitor bracket.
Screwing the monitor bracket onto the dashboard (fig. b, page 6)
➤ Hold the support base within the outlines marked beforehand.
➤ Fasten the monitor bracket with the self-tapping screws.
Fastening the monitor
➤ Set the monitor on the monitor bracket and secure it with the knurled nut (fig. a, page 6).
➤ Slide the cover over the monitor bracket on the monitor.
EN
Installing the LCD monitor
15