Connecting - Nowsonic DBOX ONE Manual Del Usuario

DBOX ONE
GB
User manual

Connecting

1) A DI box converts an unbalanced signal of an electric guitar or a
keyboard into a balanced signal for connecting to any microphone
input of a mixing console or microphone preamplifier. In addition,
the impedance of the Hi-Z signal is adapted to the low-impedance
input.
2) In order to obtain the best sound quality, please use only high-quality
cables. Please make sure that the cables are properly connected.
3) Connect your audio source (e.g. electrical guitar, bass, keyboard etc.)
to the INPUT jack.
Tip
In Phase (+)
Sleeve
Ground
4) If you want to loop-thru the input signal to a guitar amplifier etc.,
connect the LINK output to the input of the amplifier using a stan-
dard mono jack cable.
5) If any noise occurs, please activate the Ground-Lift switch. In additi-
on, you may adapt the input gain using the PAD switch as required
(+20dB for low-level line sources, 0dB for electric guitars, -30dB for
power amplifier outputs) if any clipping occurs.
6) Connect the OUTPUT socket with any XLR microphone preamplifier
input on your mixing desk using a balanced XLR cable.
7
www.nowsonic.com
Pin 1: Ground
Pin 2: Hot (+)
Pin 3: Cold (-)