Service And Maintenance - Festool TP 220 Manual De Instrucciones

Work breaks and finishing work
Always attach the protective cover to the device

after finishing work [Fig. 3].
7

Service and maintenance

Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/service
5
3
2
1
Information on REACh: www.festool.com/reach
7.1 Replacing the blade rollers
CAUTION
Sharp, pointed edges!
Risk of injury!
Handle the device with extra care and always

wear suitable protective gloves.
[Fig. 5]
Loosen the flat head screws by turning the aux-

iliary plates at either end of the roller in oppo-
site directions.
Remove the first roller.

Remove the second roller from the device to-

gether with the shaft and then pull the roller
from the shaft.
Slide a new roller onto the shaft.

Note: The points on the roller should
always point towards the centre of
the device.
Insert the roller with shaft into the device and

attach the second roller (Note direction!).
Tighten the two screws.

Replace the second pair of rollers in the same
way.
 The play of the blade rollers ensures that the
device will function correctly over slightly un-
even surfaces.
8 Accessories
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
TP 220
GB
9