Temperature Setting; Fan Speed Setting; Navigating Through The Main Menu - Mitsubishi Electric PCA-M71HA Serie Manual De Instrucciones

3. Operation

3.3. Temperature setting

<Cool, Dry, and Heat>
Fri
28
Room
Cool Set temp.
Mode Temp. Fan
F1 F2 F3 F4
Press the [F2] button to decrease the preset temperature, and press the
[F3] button to increase.
• Refer to the table on page 4 for the settable temperature range for dif-
ferent operation modes.
• Preset temperature range cannot be set for Fan/Ventilation operation.
• Preset temperature will be displayed either in Centigrade in 1-degree
increments, or in Fahrenheit, depending on the indoor unit model and
the display mode setting on the remote controller.

3.4. Fan speed setting

Fri
28
Room
Cool Set temp.
Mode Temp. Fan
F1 F2 F3 F4
Press the [F4] button to go through the fan speeds in the following order.
Note:
In the following cases, the actual fan speed generated by the unit will differ
from the speed shown the remote controller display.
1. While the display is showing "STAND BY" or "DEFROST".
2. When the temperature of the heat exchanger is low in the heat mode. (e.g.
immediately after heat operation starts)
3. In HEAT mode, when room temperature is higher than the temperature
setting.
4. When the unit is in DRY mode.
3.5. Airflow direction setting

3.5.1 Navigating through the Main menu

<Accessing the Main menu>
Main Main menu
Operation
F1 F2 F3 F4
Fri
28
Room
Cool Set temp.
Mode Temp. Fan
Example display
(Centigrade in 1-degree increments)
Press the [MENU] button on the
Main display.
The Main menu will appear.
<Item selection>
Main Main menu
Initial setting
F1 F2 F3 F4
<Exiting the Main menu screen>
Fri
Room
Cool Set temp.
Mode Temp. Fan
F1 F2 F3 F4
<Display of unsupported functions>
Title
Not available
Unsupported function
Return:
F1 F2 F3 F4
Press [F2] to move the cursor left.
Press [F3] to move the cursor right.
Press the [RETURN] button to exit
the Main menu and return to the
Main display.
If no buttons are touched for 10
minutes, the screen will automati-
cally return to the Main display.
Any settings that have not been
saved will be lost.
The message at left will appear if
the user selects a function not sup-
ported by the corresponding indoor
unit model.
en
5