Emission Levels; Technical Data; Machine Features - Festool C 15 Li Manual De Instrucciones

– Protect the battery pack from excessive heat > 50
°C or constant heat sources such as sunlight or
naked flames!
– Never use water to extinguish burning li-ion bat-
tery packs! Use sand or a fire blanket.
– Check the plug and the cable regularly and
should either become damaged, in order to avoid
a hazard, have them replaced by an authorised
after-sales service workshop.
– Always pull the mains plug out of the socket
when the charger is not in use.
2.4

Emission levels

Levels determined in accordance with EN 60745 are
typically:
Sound pressure level
Sound power level
Uncertainty
Wear ear protection.
Vibration emission value a
directions) and uncertainty K measured in accor-
dance with EN 60745:
Drilling in metal
Fastening
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
3 Intended use
Cordless drill suitable for
– drilling in metal, wood, plastic and similar mate-
rials,
– inserting and tightening screws
– use with Festool batteries BPC and BPS of the
same voltage.
Charger TCL 3 suitable for
L = 65 dB(A)
PA
L = 76 dB(A)
WA
K = 3 dB
(vector sum for three
h
a = 3,5 m/s
h
K = 1,5 m/s
a < 2,5 m/s
h
K = 1,5 m/s
– charging Festool battery packs: BP, BPS and
BPC (NiMH, NiCd, li-ion are recognised automat-
ically.)
– indoor use only.
The user is liable for improper or non-in-
tended use; this also includes continuous in-
dustrial operation.
4

Technical data

Cordless drill
Motor voltage
Idle engine speed*
Max. torque
Soft material (wood)
Hard material (metal)
Adjustable torque**
Chuck clamping range
2
Drill diameter max.
2
2
2
Tool holder in drill spindle
Weight without battery pack with
Centrotec
* Speed specifications with fully charged battery
pack.
** The maximum speed is reduced in the lower
torque stages.

Further technical data on the charger and bat-
tery packs can be found on page 6.
5

Machine features

[1-1] Torque thumbwheel
[1-2] Bit store
[1-3] LED lamp
[1-4] Gear switch
[1-5] Drilling symbol
[1-6] Screwdriving symbol
[1-7] Drilling/Fastening selector switch
[1-8] Right/left switch
[1-9] On/Off switch
[1-10] Capacity display
C 15 Li
GB
C 15 Li
14,4 - 15,6 V
1st gear 0 - 450 min
2nd gear 0 - 1500 min
25 Nm
40 Nm
1st gear 0,5 - 8 Nm
2nd gear 0,5 - 6 Nm
1,5 - 13 mm
Wood 35 mm
Metal 16 mm
1/4"
1,0 kg
-1
-1
13