Adding A Second V7 - Numark V7 Guia De Inicio Rapido

ADDING A SECOND V7

To complete a dual-V7 setup, set up one V7 (as
described above) then follow these steps:
AC IN 100V AC IN 100V-240V -240V
50-60Hz 50W 50-60Hz 50W
POWER POWER
USB USB LINK LINK
1. Connect the V7s' LINK CONNECTIONS to each other with the included link cable.
2. Use the DECK SELECT switches to set the left V7 as "Deck A" and the right as "Deck B."
Note: Do not change the switches during your session.
3. Make sure your first V7 is connected a USB port on your computer then open Serato ITCH. It will
automatically detect the V7s.
4. Check for the following:
a. On the V7 connected to your computer, the MASTER BUTTON should be lit. (If not, then press
it.)
b. On the V7 connected to your computer, the USB LED should be lit.
c. On the V7 that is not directly connected to your computer, the MASTER BUTTON should be unlit.
(If not, then press it.)
d. On the V7 that is not directly connected to your computer, the USB LED should be unlit.
e. Both V7s' LINK LEDs should be lit. (If not, then reconnect them securely with the link cable.)
DECK B DECK B DECK A DECK A
L L
DECK DECK REMOTE REMOTE MOTOR MOTOR
LOCA LOCATION TION TORQUE TORQUE
RIGHT RIGHT LEFT LEFT HIGH HIGH LOW LOW
R R
OUTPUT OUTPUT
Warning: Do NOT connect two V7s to the
same computer via USB!
7
AC IN 100V-240V
50-60Hz 50W
POWER
USB LINK DECK REMOTE
LOCATION
RIGHT LEFT
DECK B DECK A
L L
MOTOR
TORQUE
HIGH LOW
R R
OUTPUT