Publicidad
Idiomas disponibles
Idiomas disponibles
_
('7"_-- File Rail Edges_
17 [-1
I"1
and Sides
I U I
Square
I
I
Worn Groove
Correct Groove
Replace the guide bar when the groove
is worn, the guide bar is bent or cracked,
or when excess heating or burring of the
rails occurs.
If replacement
is neces-
sary, use only the guide bar specified for
your saw in the repair parts list or on the
decal located on the chain saw.
LUBRICATION
Bar Oil
• Check bar and chain oil before use
and every 15 minutes while operating
the saw. See GUIDE BAR AND CHAIN
OIL under the OPERATION section.
INSPECT AND CLEAN UNIT AND
LABELS
• After each use, inspect complete unit
for loose or damaged parts. Clean the
unit and labels using a damp cloth with
a mild detergent.
• Wipe off the unit and labels with a
clean dry cloth.
CHAIN SHARPENING
Chain
sharpening
requires
special
tools.
You can purchase sharpening
tools at an authorized service dealer or
go to a professional
chain sharpener.
_/L WARNING:
Avoid accidental start-
ing. Always
unplug saw from power
source before installing
a bar and/or
chain.
CHAIN REPLACEMENT
_/L WARNING:
Wear
protective
gloves when handling chain. The chain
is sharp and can cut you even when it is
not moving.
It is normal for a new chain to stretch dur-
ing the first 15 minutes of operation. You
should recheck your chain tension fre-
quently and adjust the chain tension as
required.
See CHECK CHAIN TENSION
section.
Replace the old chain when it becomes
worn or damaged.
Use only the Low
Kickback
replacement
chain specified
in the list of available replacement parts.
The chain must complywith
kickback re-
quirements of ANSI B175.1 when tested
with this saw.
See an authorized service dealer to re-
place and sharpen individual cutters on
your chain.
TO REPLACE CHAIN:
1. Disconnect
the chain saw from the
power source.
2. Turn the unit upside down on a flat
surface. Straighten
out chain, then
lay it on a flat surface.
3, Remove
bar mounting
nuts,
bar
clamp plate, and old chain.
4. Turn the adjusting
screw counter-
clockwise to move the adjusting pin
almost as far as it will go to the rear.
Do not remove the adjusting screw
from the unit.
5. Hold chain with cutters facing
as
shown.
@_
ip of
Bar
DIRECTION
OF ROTATION
13
Publicidad
