VOSS.garden EXTRA POWER 9V Manual De Instrucciones página 3

Specific Operating Instructions
4 5
Normal operation with 9V dry battery; alternatively, the appliance can be
operated with a 12V wet accumulator!
This energizer shall not be used as an animal trainer (inside a barn).
a.) Installation
Assemble the earth electrode (3) as shown in the above figure; screw the earth connecting cable (7) onto the
earth electrode with the fastening screw. Drive the earth electrode into the ground and place the energizer
aside, see above figure.
b.) Functional description of the device

The device is opened by pressing both sides of the cover while simultaneously pulling up.

Place the battery in the case and connect the device. Close the cover.
(Only operate the device in the upright position and with the cover firmly latched)
Commissioning the device without connection of the fence system:

Switch on the device by pressing the button [4]

If the control lamp [5] blinks (twice) in an interval of approx. 1.3 sec., the device is functional and in
EXTREME mode (high shock strength with higher current consumption).

If the button [4] is pressed for a second time, the device switches to ECO mode with lower output
and current consumption. This is displayed by single blinking at an interval of approx. 1.3 sec.

If the button [4] is pressed for a third time, the device is switched off. (no blinking)
Hint:
If the control lamp [5] does not blink or blinks red after switching on, the battery must be checked for correct
polarity and a minimum voltage of approx. 6V or the device must be inspected by a specialty technician!
c.) Functional description with connected fence system (fence + earthing)
If the control lamp [5] blinks red (battery voltage less than 6V), the battery must be replaced.
The control lamp [5] only serves as a functional check and does not react to faults in the fence system or
outage of fence voltage.
Therefore, periodic checking of the voltage (>2.5 kV) on the fence is essential.
The device provides 12v operation with total discharge protection. This is indicated by red blinking of the pilot
lamp.
If the control lamp [5] should blink faster than 1x per second, the device must be switched off immediately and
inspected by a specialty technician before re-commissioning.
Any user of electric fence systems is legally indebted to control the fence-appliance and the fence system
regularly, in accordance with the conditions of use, at least once per day.
- visual check of the appliance and the fence system
- measurement of the minimum voltage of 2500V at each point of the fence
2
7
4
1.
2.
3.
1
6
3
5
OFF
3
EXTRA POWER 9V
1 Earth connection
2 Fence connection
3 Earth electrode
4 ON / OFF switch
5 Indicator light
6 Drilled hole for 12V cable
-EN-
Version : 2019.1