Safety Regulations - Rapid 5050e Manual Para El Usuario

gb
INTRODUCTION
This Operator's Manual describes the Rapid 5050e and 5080e.
Read the operator's manual carefully before using the machine.
The manual contains safety regulations and descriptions of checks on parts
which are critical for safety, together with directions for the correct use and
maintenance of the machine. The figures can be found on the cover fold-out.

SAFETY REGULATIONS

– The machine may only be used by personnel with knowledge of the safety regulations
and correct handling as described in this manual.
– The machine must only be used with the supplied adapter noted on the machine
data plate (B)
– The visor must be mounted at the machine when stapling.
– Only the papers (or other objects) to be stapled should be put into position under
the visor.
– It must not be possible to staple without the visor mounted. Check on this every day as
described in the section "Checking safety functions".
– The machine must be turned off before it is moved.
– The machine must not be subjected to moisture. It must not be located in a position
where rain or splashes of water can fall on it.
– Repairs and other measures, besides those described in this manual, must be carried
out by service personnel authorised by Isaberg AB, its companies or agents.
– Repair of faults or damage to the machine or its electrical connection must be carried
out by authorised service personnel.
SYMBOLS
Symbols in this manual
Read the operator's manual carefully and make sure you understand
it properly before using the machine.
Warning text. Information critical for safety follows after this symbol.
31
Symbols on the machine
See figure 1.
A Forbidden to put fingers underneath the visor.
B Rating plate with the following data:
C ETL approval mark (This mark will be found on machines sold in certain countries).
Symbols on the adapter
See figure 1.
D Rating plate with the following data:
DESCRIPTION
The Rapid 5050e/5080e is an electrically powered desktop stapler. Stapling
is automatic when the object to be stapled is pushed into position under the visor.
The parts of the machine are shown in figure 2.
A Warning decal
B
Data plate, stapler
C Markings
D Data plate, adapter
E
Locking knob, visor
F Visor
G
Cassette
Manufacturer.
Type designation of machine.
Serial number.
Adapter.
Max. number of staples per minute.
CE mark for compliance according to EU
Directive
Year of manufacture.
Manufacturer.
Type designation.
Electrical data.
Marking for type approval.
CE mark for compliance according to EU
Year of manufacture.
H
Low staples warning light
J Mounting groove for table
K Lever for adjusting the staple depth
L
Adapter
M Connection for pedal trigger
N
Connection for adapter
gb
32