Truvision Device Finder - Ip Addressing - Interlogix TruVision NVR 20 Guia De Inicio Rapido

Figure 5: TVN 20 back panel
Table 2: Back panel elements
No. Element
1 Reset
2 RS-232
3 LAN
4 eSATA
5 RS-485 Switch
6 RS-485
Connectors
7 Alarm In
8 Alarm Out
9 GND
10 POWER Plug
11 Power Switch
TruVision Device Finder - IP
addressing
The default IP address of the TVN 20 is 192.168.1.82.
However, the TruVision Device Finder Tool is a faster
and simpler way to discover the TVN 20 and to quickly
change the IP address of the unit to match your network
needs.
This tool automatically identifies TruVision devices that
support "auto-discovery" anywhere on the network even
different subnets. The User can view and modify the IP
address of any discovered devices. The Device Finder
only detects devices on the same LAN and does not
detect devices across a VLAN. If you device is not
discovered you can configure the devices manually.
1. Insert the TVN 20 Product Documentation CD
included with your unit into a PC that will view video
from the TVN 20 unit.
EN ‐ 4
Description
Resets unit to factory defaults
Used for connecting PC for troubleshooting
10/100/1000Mbps UTP Ethernet interface
For future use
For future use
For future use
16 alarm inputs (NO/NC)
4 relay outputs
Grounding point
Connection for power cord
Power On/Off (use the Power Button on front of unit to turn power off to the unit.)
2. Browse to the folder IP Discovery Tool and double
click on the Setup icon in the folder.
3. Click Ok to all of the prompts and the default
settings. At the end of the quick install process the
application will install a TruVision Device Finder
shortcut on the desktop.
4. Double click the shortcut.
5. From the TruVision Device Finder start page, Press
Start.
The detection process will take only a few moments
to discover all supported TruVision devices (TVN 20,
New TruVision 1.3 and 2.0 MpX cameras as well as
TVR 10 and TVR 60).
TruVision NVR 20 Quick Start Guide