Installation; Faucet Assembly/Installation - Westinghouse QL292 Manual Del Usuario

Installation

FAUCET ASSEMBLY/INSTALLATION

1 . Connect the faucet head to the hose . Push the hose in so that the
head aligns properly with the notches on the faucet pipe .
2 . Remove the gasket, metal washer, and retaining nut from the
faucet body .
3 . Install the faucet through the hole in the sink such that the faucet
body completely covers the hole .
4 . From underneath, secure the faucet to the sink with the gasket,
metal washer, and retaining nut .
5 . Tighten the retaining nut by hand until it is snug . Use a wrench
to tighten the assembly . Gently tighten the two screws on the
retaining nut . Do not over tighten .
6 . Hand-tighten the hose to the faucet outlet. Tighten the fittings
using two wrenches . Hold the faucet outlet steady with a wrench
while turning the hose fitting with another wrench until it is snug.
Failing to use two wrenches can damage the faucet . Do not over-
tighten .
7 . Install the counterweight a couple of inches from the bottom of the
hose on the side closest to the faucet head . There should be no
slack in the hose .
8 . Connect the water supply lines (not supplied) to the faucet .
QL292
Faucet body
Gasket
Retaining nut
Counterweight
Water Supply Lines
6
Faucet
neck
Spray
head
Sink
Metal Washer
Screws
Faucet
outlet
Hose
Faucet outlet
Hose