Switching The Clipper On And Off; Using The Clipper; Replacing The Clipping Blades - Heiniger Xpert 2-Speed Instrucciones De Uso

CAUTION!
The upper blade of the shearing head is only held by the ta-
X X
pered pins of the chicken feet. If the shear-pressure adjustment
head is released too much, the upper blade can fly off and
result in injuries.
NOTE!
If the clipping pressure is too low, hair can gather between the
X X
clipping blades. This results in a poor clipping quality. In this
case, clean the clipping blades as described in chapter 6.7.
6.3

Switching the clipper on and off

Fig. 4
6.4

Using the clipper

Approach the animal from the front.
X X
Secure the animal to be clipped and calm it down.
X X
Plug the power plug into the socket.
X X
Switch the clipper on while you are in the visual range of the animal.
X X
Select the desired speed (level I or II).
X X
Observe the animal's behaviour while clipping.
X X
Switch the clipper off after you have finished clipping and pull the plug
X X
from the socket.
6.5

Replacing the clipping blades

Fig. 5
12
X
0
I
II
X
X
X
X
X
Instruction Manual / Xpert 2-Speed sheep clipper
To switch the clipper on, slide the
X
ON/OFF switch to the position I or II.
To switch the clipper off, slide the
X
ON/OFF switch to the position 0 (see
Fig. 4).
Switch the clipper off by sliding the
X
switch to the position 0.
Pull the plug from the socket.
X
Turn the adjusting knob in the direc-
X
tion of the arrow until the resistance
decreases.
Place the clipper with the comb plate
X
screws facing upwards on a flat sur-
face.