Storage; Cutter Plates; Cutter Plates Compatible With Cutter Head Gt647 Cattle Version; Gt657 Horse Version - B.Braun Aesculap Instrucciones De Manejo

Cleaning the cutter head
►
The cutter head must be cleaned at least after each day of clipping time
or if it gets dirty.
►
Unlock and remove the lithium ion battery 21.
►
Remove both screws 14, see Fig. B.
►
Turn the cutter head very slightly (about 15°) counterclockwise and
remove it from the motor shell.
►
Remove cutter plates; see Changing cutter plates.
►
Thoroughly clean the interior part and individual parts of the cutter
head using a brush.
►
Insert the cutter plate and tighten, see Changing cutter plates.
►
Grease gear wheel, see Greasing gear wheel.
►
Carefully place the cutter head on the motor. When re-attaching the
cutter head, ensure that it is turned 15° counterclockwise in such a
way that its lower flange engages with the groove of the motor hous-
ing.
►
Lubricate the shearing head, see Lubricating the shearing head
Re-sharpen the cutter plates
►
For sharpening the cutting plate, please contact Technical Service, see
Technical Service.
4.6

Storage

►
Clean the clipping machine and cutter plates thoroughly before storing,
see Reprocessing.
►
Store the clipping machine in a dry, dark and clean room.
5.

Cutter plates

5.1 Cutter plates compatible with cutter head GT647
Cattle version / GT657 Horse version
Art. no. Designation
GT501 Upper cutter plate with 15 cutting teeth
GT502 Lower cutter plate with 31 cutting teeth 3 mm cutting
height
GT503 Upper cutter plate with 17 cutting teeth
GT504 Lower cutter plate with 18 cutting teeth 3 mm cutting
height
GT505 Upper cutter plate with 23 cutting teeth
GT506 Lower cutter plate with 23 cutting teeth 3 mm cutting
height
GT508 Lower cutter plate with 51 cutting teeth 1 mm cutting
height
GT510 Like GT506, but with cutting height of 5 mm
GT511 As GT502, but with cutting height of 1 mm
5.2

Recommended combinations

Combination Upper/lower plate
closely spaced GT501/GT502
teeth
GT501/GT511
GT505/GT502
GT505/GT508
GT505/GT511
medium spaced GT505/GT506
teeth
GT505/GT510
widely spaced GT503/GT504
teeth
6.

Reprocessing

6.1

Cleaning/disinfection

Risk of electric shock and fire hazard!
Before cleaning:
►
DANGER
– Remove the mains plug from the
charger.
– Unlock the Li-ion battery and
remove from the battery-oper-
ated clipping machine.
Do not use flammable or explosive
►
cleaning or disinfecting solutions.
Ensure that no fluids will penetrate
►
the product.
Damage to, or destruction of the prod-
uct caused by mechanical clean-
CAUTION
ing/disinfection!
Only clean and disinfect the product
►
manually.
Do not sterilize the product under
►
any circumstances.
en
Suitable for
Cattle and horses (normal con-
figuration)
Industrial shearing
Horses and cattle – smooth
standard shearing
Horses, cattle (udder shearing)
and industrial shearing
Horses and cattle – for very
fine, smooth shearing
Cattle, dogs and goats
Dogs and goats
Cattle, sheep and thin-wooled
sheep
7