Phonic i7300 Manual Del Usuario página 10

Setting The Footswitch
Changing Function
First, press the System button; the first option that appears
will be "Foot switch." simply turn the adjust control to
alternate the function of the foot switch between "Program
select" and "bypass"modes. you selection is applied
automatically.
Changing Effect Selection Properties
When the footswitch's functions is set to 'Program select,'
pushing to system key twice will bring up a menu that
allows you to alter the properties of this preset selection.
by turning to adjust control you can change the footswitch
program select "destination" program, between 1 to 100.
this means you can use the foot switch to jump through
then start all over again.
Compare / Bypass
the compare / bypass key, located on the ReverbMaster's
fron panel, generally acts as a bypass key, stopping any
effects from being applied to the audio. Pressing it a
second time will deactivate bypass mode and return to
your chosen effect. When the bypass key is pressed the
key's imbedded leD will illuminate.
you can also activate a bypass on each of the separate
stages of Reverb (the Pre, the Post and the Main effect
– as shown in the diagram below). by simply pressing the
edit key and disabling them through their corresponding
menus (ie. turning them off). the bypass can be
deactivated by turning them on once more.
6
When editing effects, the compare/bypass key acts as a
compare Key, allowing you to revert back to the original
preset used before starting to edit the effect – enabling
you to hear the difference in the two effects. Pushing the
button a second time will revert you back to the edited
program.
Storing Edited Presets
First of all, complete all your alterations to your effect
in "edit" mode (changing reverb time, delay or other
corresponding options). then, to store, simply press the
store key, where you will then be allowed to select which
preset slot you wish to fill. Use the Adjust Control to scroll
to the preset slot you wish to use and press the control
down to confirm. This will then move you to the name edit
section, where you can edit the individual letters of the
preset name. the curser is located underneath the letters
of the title. use the adjust control to scroll to any letter
you wish to change, press the control down to select, and
use the control once more to scroll through the various
letters and characters that can be used. Pressing the
control once more will finalize, and you can then move
to the next letter you want to edit. Pressing the store key
again will complete the saving process.
Auto Saving Settings
the i700 will automatically save changes to any
parameters you may set (presets, reverb edits, MiDi
settings, etcetera), and keep them – even after the power
is turned off. this ensures none of your settings are lost in
the event of power outages.
i700