Turbo Operation - Haier HSU-09TK/R32DB-IN Operación Manual

Operation
Comfortable SLEEP
SLEEP
Press button , the remote controller will
show , and then achieve to the sleep function.
Press again this
SLEEP
be cancelled.
Operation Mode
1. In COOL,DRY mode
1 hours after SLEEP mode starts,temp.will become
1 O C higher than temp.setting.After another 1 hours,
temp.risesby 1 O futher .The unit will run for further
C
6 hours then stops Temp. is higher than temp.setting
so that room temperature won't be too low for your
sleep.
SLEEP operation starts
1 hr
1 hr
Temp.setting
In COOL, DRY mode
2.In HEAT mode
1 hours after SLEEP mode starts, temp will become
O
2 C lower than temp.setting. After another 1 hours,
O
temp decrease by 2 C further. After more another
3 hours, temp.risesby 1 C further.The unit will run
for further 3 hours then stops.Temp. is lower than
temp. setting so that room temperature won't be too
high foryour sleep.
Temp.setting
1 hr
1 hr
SLEEP
operation starts
3.In AUTO mode
The unit operates in corr
corresponding sleep mode adapted to the
automatically selected operation mode.
4. In FAN mode
It has no SLEEP function.
3
button , the sleep function will
SLEEP operation stops
Approx.6hrs
O
Rises 1 C
O
Rises 1 C
Unit stop
O
Unit stop
O C
Decreases 2
O
Decreases 2 C
3 hrs
3 hrs
O
Rises 1 C
SLEEP
operation stops
In HEAT mode
esponding sleep mode
●
5. When quiet sleeping function is set to 8 hours the quiet
sleeping time can not be adjusted.When TIMER function is
set,the quiet sleeping function can't be set up.After the
sleeping function is set up,if user resets TIMER function, the
sleeping function will be cancelled; the machine will be in the
state of timing-on,if the two
time,
either of their operation time is ended first,the unit will
stop automatically,and the other mode will be cancelled.
Note
When TIMER function is set, the sleeping function can't be
set up .After the sleeping function is set up
TIMER function, the sleeping function will be cancelled; the
machine will be in the state of timing-on.
Note to the power failure resume:
press the sleep button ten times in five seconds and enter
function after hearing four sounds.And press the sleep button
ten times within five seconds and leave this function after
hearing two sounds.
Power Failure Resume Function
If the unit is started for the first time, the compressor will not
start running unless 3 minutes have elapsed. When the power
resumes after power failure, the unit will run automatically,
and 3 minutes later the compressor starts running.

TURBO Operation

(This function is unavailable on some models.)
TURBO Operation
When you need rapid heating or cooling, you can use this function.
Press TURBO button, the remote controller will show
and then achieve to the turbo function. Press again this
TURBO button , the turbo function will be cancelled.
Note
During TURBO operation, in rapid COOL mode , the room
will show inhomogeneous temperature distribution.
modes are set up at the same
,
if user resets
,