Care and Maintenance
Check/Clean
the Stainless
Steel
inner Door and Tub
Clean the outer edges of the inside door panel
regularly
to remove debris that might collect there
from normal
loading.
If spots begin to appear on the stainless
steel tub
or inner door, make sure the rinse agent reservoir
is full.
Check/Clean
the Spray Arm
Nozzles
Occasionally
check the spray arms to ensure that
the spray arm nozzles
(holes)
are unobstructed.
You must remove the spray arms to check them
for obstruction.
To remove
the top spray arm:
1. Remove
the empty top rack from the
dishwasher.
Figure 19
=
=
=
Turn the
rack upside-
down. The
top spray
arm is held
in position
by a locking
nut as
shown in
Figure 19A.
Turn the
locking nut
counter-
clockwise
1/8 turn and
remove
it,
as shown in Figure 19B to release
the spray
arm.
Remove
the spray arm as shown
in Figure
20.
Figure 20
Look for
obstruction
in the spray
nozzles.
=
If the spray
nozzles
need
cleaning,
flush them
under running water.
12
To reinstall
the top spray
arm:
1. Return the top spray arm to its installed
position.
2. Return the locking nut to its installed
position
and turn it 1/8 turn clockwise.
3. Return the top rack to the top rack roller
guides.
To remove
the bottom
spray
arm:
1. Remove
the empty bottom
rack from the
dishwasher
tub.
2. Grasp and lift the bottom spray arm
as
shown in
Figure 21
Figure 21.
3. Look for
obstruction
in the
spray
nozzles.
4. If the spray
nozzles
need
cleaning,
flush them under running water.
To reinstall
the bottom
spray
arm:
1. Return the bottom
spray arm to its installed
position
and press it so that it snaps into
place.
2. Return the bottom
rack to its installed
position.
Check/Clean
the
Filter
System
This dishwasher
has a filter system
that consists
of a Large Object Trap/Cylinder
Filter assembly
and a Fine Filter. The filter system
is located
on
the inside of your dishwasher
under the lower
rack and is easily accessible.
During
normal
use, the filter system
is
self-cleaning.
You should
occasionally
inspect
it
for foreign objects
and clean it when necessary.
To Remove
the Large
Object
Trap/Cylinder
FilterAssembly:
1. Remove
the bottom
rack,
2. Grasp the
assembly
as
shown in
Figure 22 and
turn it
counter-
clockwise
1/4 turn.
Figure 22