Important - Delta 20-950 Manual De Instrucciones

ATTACHING THE HEADSTOCK TO THE COLUMN
RISK OF PERSONAL INJURY - The head-
sttock is very heavy. Use two or more people to place the
headstock on the column.
Place the drill press head (K) Fig. 15 on the column as far
as it will go. Align the head (K) Fig. 15 with the table (L) and
the base (M). Tighten the two head-locking screws (N) Fig.
16 with the 5mm wrench supplied.
Fig. 16
INSTALLING THE CHUCK
IMPORTANT: Make certain that the tapered hole in the
bottom of spindle (T) Fig. 17, and the taper on the spindle
adapter (U) are clean and free of grease, lacquer, or rust-
preventive coatings.
NOTE: Household oven cleaner can effectively remove these
coatings from the spindle and spindle adapter. However,
carefully follow the manufacturer's safety rules regarding its
use.
Push the spindle adapter (U) Fig. 17 into the spindle (T).
making certain that the tang (V) engages the mating slot
inside the spindle (T).
RISK OF PROPERTY DAMAGE. To
avoid damage to the laser, prevent the cleaning solution
from coming in contact with the laser pod. You can
clean the laser pod with a dry cotton cloth.
IMPORTANT: Make certain the spindle taper (O) Fig. 18,
and tapered hole in chuck (P) are clean and free of any
grease, lacquer, or rust preventive coatings.
NOTE: Household oven cleaner can effectively remove any
substance from the chuck. However, carefully follow the
manufacturer's safety rules concerning its use.
IMPORTANT: Open the chuck jaws as wide as possible,
making sure that the chuck jaws are inside the chuck.
N
V
Fig. 17
Fig. 18
10
K
L
M
Fig. 15
T
U
O
P