Software Installation - König Electronic SEC-CAMIP40 Manual De Uso

NETWORK CABLE
What you should know about the Homeplug:
Try to avoid using a surge protector distribution board. Some surge protector distribution boards may
cause disconnection of the signal.
Three-phase power system. Please make sure that the Homeplug and the IP Camera are connected at
the same power phase; otherwise it may cause disconnection of the signal.
The system supports AC 100V~240V, but the Homeplug and IP camera must be connected in the same
voltage environment, otherwise it may cause disconnection of the signal.
One Homeplug does not support more than 16 IP cameras. It does not allow two Homeplugs to be set
up in one network in case of a mistake in network connection.
The entire system has a connection distance limited to 300 metres.

Software installation:

Insert the software CD in your CD-R
device, start the installation
Choose Shelexec.exe to start installing
the software
or
check the disc contents and click the
startup.html file to open the start up
page
Select ENGLISH to start the installation
of the software
Note: the IP CAM SYSTEM software is
only in English
Description of the Homeplug:
POWER: RED, power ON
GREEN, connection quality is good
LINK: ORANGE, connection quality is fair
RED, connection quality is bad
ETHERNET: BLINKING, Ethernet traffic detected
4