Connecting A Vcr - Samsung LN-T2353H Manual Del Usuario

Connecting a VCR
Video Connection
These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the
instructions on pages 7-8). Skip step 1 if you have not yet connected to an antenna or a cable system.
1. Unplug the cable or antenna
from the back of the TV.
2, Connect the cable or antenna
to the ANT IN terminal on the
back of the VCR.
Connect an RF Cable between
theANT OUT terminal on the
VCR and the ANT 1 IN (AIR)or
ANT 2 IN (CABLE) terminal on
the TV.
Connect a Video Cable
between the VIDEO OUT jack
on the VCR and theAV IN 1 (or
AV IN 2) [VIDEO] jack on the
TV.
Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AVlN 1 (orAV IN 2)[R-
AUDIO-L] jacks on the TV.
If you have a "mono"
(non-stereo) VCR, use a
Y-connector (not supplied)
to hook up to the right
and left audio input jacks
of the TV. If your VCR
is stereo, you must
connect two cables.
VCR Rear Panel
TV Rear Panel
RF Cable tNot supplied)
Follow the instructionsin "Viewing a VCR or Camcorder Tape" to view your VCR tape.
>_ Each VCR has a different back panel configuration.
When connecting a VCR_ match the color of the connection terminal to the cable.
S=Video Connection
Your Samsung TV can be connected to an S-Video signal from an VCR.
(This connection delivers a better picture as compared to a standard VCR)
1. To begin_ follow steps 1-3
in the previous section to
connect the antenna or
cable to your VCR and
your TV.
Connect an S-Video Cable
between the S-VIDEO OUT
jack on the VCR and the
AV IN1 [S-VIDEO] jack on
the TV.
Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN1 [R-AUDIO-L] jacks
on the TV.
TV Rear Panel
An S-Videocable may be included with a VCR. (If not,check your local electronicsstore.)
>- Each VCR has a different back panel configuration.
:_ When connecting a VCR, match the color of the connection terminal to the cable.