Orbegozo SP 6500 Manual De Instrucciones página 18

SP 6500
Note: note: above setting time/day will keep as long as switch on or stand by. If main switch off or power
cut off, or plug out, it need reset. You can press
5. Set temperature. During working status, press "
to set desired temperature (temperature range 10-49ºC), press
seconds. For example：the current room temperature is 15℃, when set temperature to 25ºC, the display
shows as following pic. If want to cancel the set temperature, press
instead of set temperature. "ºC" light turn off.
Note: when setting temperature, it will use smart working way as follows:
- If room temperature is 2ºc or lower than set temperature, the heater will work in max power heating.
- If room temperature is less than 2ºc of set temperature without reach it, heater will work in min power
heating.
- If room temperature is the same as set temperature, heater will work in fan mode for 30 seconds to cool
down the appliance and protect its components, after that it will enter in standby mode.
- After this situation if room temperature is lower than 2ºc of set temperature, heater will turn on again
and work as same way.
6. Set weekly program (only by remote control)
A. Press , the product enter into working status.
B. After set current hour/day as point 4 explains, follow next instructions to set weekly program.
C. Press , the display shows "p", it enter into weekly program setting.(pic. A)
D. Press , the display shows d1~d7, set to working days as required (Monday-Sunday: d1~d7). Such
as set Monday, the display as (pic. B)
Note: in order to distinguish between setting current day & working period of the day: current day -
Monday-Sunday: d1~d7; working period - each day: p1~p6.
E. Press , the display shows p1~p6 (for each day, it can be set maximum 6 time periods).for example,
1st period setting.(figure c).
F. Press , the display shows "00"as default. Press
as set the turn-on time 7:00am (as figure d ) (memo: the setting time 0-24 for choice).
to check you set current time / day.
/ ", the display shows "23" as default. Press "
to confirm the setting or wait a few
continuously to set the turn-on time. Such
to set the low or high heating
/ "
18