Product Introduction; Parts; Connecting The Wi-Fi Interface - Mitsubishi Electric MAC-557IF-E Manual De Instalación

2. Product Introduction

No item
1 WPS switch
2 RESET switch It resets the system and ALL settings.
3 LED1 (Green) It shows the wireless communication state.
4 LED2 (Orange) It shows the MAC-557IF-E state.
5 LED3 (Green) It shows the local communication state.

3. Parts

Interface unit
[with connecting cable
(5-core)]
Screw for mounting
3.5×16
Screw for mounting
4×16

4. Connecting the Wi-Fi interface

(For details on each system, see the relevant instruction manual.)
The connecting cable (5-core) connected to a room air conditioner (CN105) should be mounted at
the room air conditioner or its vicinity.
Cable length outside air conditioner: less than 50cm.
Do not install the Wi-Fi interface
inside the indoor unit.
CASE1
Cable
mount
Screw
Connecting
Mounting
cable (5-core)
cord clamp
After connecting the Wi-Fi interface to the air conditioner, connect the Wi-Fi interface to the access
point (to communicate with the server).
For this Wi-Fi interface, the use of WPS-Push is recommended. (Refer to 6.)
1) Hold down the WPS switch on the Wi-Fi interface for about 2 seconds to activate WPS-Push.
When WPS-Push on the Wi-Fi interface is ready to communicate with the access point, LED 1
blinks at a 0.5-second interval.
2) Activate WPS-Push on the access point.
3) When WPS-Push is successfully enabled, LED 1 lights up for 5 seconds. If it failed, LED 2 lights up
for 5 seconds, so try again from step 1.
Main Causes that WPS failed are as follows.
Comunication distance (from the Wi-Fi interface to access point), access point settings
(encryption, authentication, limit of connections, etc.)
Refer to the instruction manual for more information.
4
Description
It activates WPS.
CASE2
Screw
Mounting
cord
clamp
1
2
Mounting cord
1
clamp
Fastener
1
(for bundling the wires)
1
Screw
Taken out from
the left side
3
4
5
1
1
Screw
Taken out from
the right side